The Spark R&D ST 2nd Board Kit has the board side touring parts, two ST Touring Brackets and two heel rests with screws, so one pair of Spark bindings can be used on a second splitboard.

What it's for

Your bindings move between boards, but the touring brackets, heel rests and pucks stay bolted to each board. This kit covers the tour mode parts for a second board. Add a set of pucks for ride mode and the board is ready for your bindings.

How it works

Tour mode: The binding slides sideways into the offset touring bracket near the toe and the same snap ramp locks it. There are no pins or cables to handle.

Climbing wire and heel rest: T1 and ST bindings carry one climbing wire built into the baseplate. It drops onto the heel rest that is mounted to the board, at a low 12 degree or a high 18 degree position, or stows flat.

ST Touring Brackets: A custom plastic blend is overmolded on an aluminum base to form the bushings the binding pivots on.

Crampon interface: ST Touring Brackets have mounting claws for the Spark Ibex crampon. Spark lists the Ibex ST for Arc, Surge, Magneto, AfterBurner, Burton Hitchhiker, Nitro Vertical and all ST bindings.

Compatibility

• Fits: Spark R&D Tesla T1 bindings, Burton Hitchhiker bindings and Nitro Vertical bindings
• Does not fit: Spark R&D Tesla bindings (per the kit page) or Spark pin mount bindings

Setup and installation

• Brackets: Attach the ST Touring Brackets with the yellow patched screws
• Heel rests: Point the arrow toward the nose of the board and attach with the blue patched screws
• Shop service: OMG can mount the kit and pucks for you

Specs

• Weight: 151 g per pair

In the box

• ST Brackets: 2
• Heel rests: 2
• Bracket screws: 6
• Heel rest screws: 4

You will also need

• Pucks: Spark Flat Pucks or Spark Canted Pucks, sold separately