This is a single Spark R&D touring bracket, sold by Spark as the ST Bracket. It bolts to the splitboard near the toe and is what the binding pivots on in tour mode.

What it's for

Use it to replace a worn or damaged touring bracket, or to finish a second board. One bracket is needed per board half.

How it works

Tour mode: The binding slides sideways into the offset touring bracket near the toe and the same snap ramp locks it. There are no pins or cables to handle.

Smooth Touring bushings: ST stands for Smooth Touring. A custom plastic blend is overmolded on an aluminum base to form the bushings, in place of the brass bushings on older Tesla brackets.

Crampon interface: ST Touring Brackets have mounting claws for the Spark Ibex crampon. Spark lists the Ibex ST for Arc, Surge, Magneto, AfterBurner, Burton Hitchhiker, Nitro Vertical and all ST bindings.

Compatibility

• Fits: All Spark R&D ST bindings, Tesla bindings, Tesla T1 bindings, Burton Hitchhiker bindings and the Nitro Vertical binding
• Does not fit: Spark R&D pin mount bindings

Setup and installation

• Screws: Spark's setup page says to attach ST touring brackets with the yellow patched screws

In the box

• Quantity: 1 ST Touring Bracket